Motor trim – hydraulic trim for boat motors. As promised earlier, the product line of our company will be significantly expanded. We would like to present you a hydraulic trim for boat motors from STRONGER company.

In this section of our website you can familiarize yourself with the hydraulic trim for the STRONGER outboard motor. https://strongermarine.com/ru/products/pod%D1%8Aemnyk-lodochnogo-motora/

трим2

trim motor

It will be useful for customers who have a non-trim motor installed. Usually these are boat motors up to 50 horsepower.

Trim motor is really indispensable thing, because it allows you to adjust the necessary angle of attack of the boat motor on the move, especially when the boat is on the glider. It also helps to pass through shallow areas of the water. It is also necessary for the approach of the boat to the shore and transportation of the boat on the carriage. In general, it is really indispensable and necessary thing.

Our trim motor is hydraulic. In our product we use hydraulic components made in Poland. It has two elements cylinder and control station separated. This allows you to significantly increase the reliability of the device because the station will not be constantly in the water. Thanks to hydraulic hoses 1.5 meters long you can install the station hidden in any place convenient for you, thereby reducing the sound from its operation and relieve the stern of the boat from additional weight. The installed hydraulics is capable of lifting up to 1 ton of weight. This fact allows you to maintain the longevity of the device, as the mechanism will be used only at 15% of the declared capacity! The trim is made of stainless steel and powder coated with a water resistant paint. The cylinder is made of stainless steel and coated on top with a special compound, which is resistant even for use in salt water. The hydraulic power pack and cylinder have protection level IP 68.

An important element in our trim is the special insulating pads that completely isolate the stainless steel trim from touching it, both the stern of the boat and the outboard motor itself, even in the bolt-on points. These gaskets can reduce vibration from the operation of the motor by almost 70%, and they also break the sound wave, which is usually transmitted from the motor to the boat hull. Closer to spring, we will provide all the technical data for our hydraulic trim.

The electrical part will be switched by a special sealed contactor with a capacity of up to 50 Amperes.

Haa05bced1ab94b25aaa56331634b7b6aU_трим

The trim will be controlled in several ways. It could just be a remote button

STRONGER_06

it can be a radio remote control,

80N3541-1024x683

or it can be a special panel with the ability to fine-tune the position of the motor, as well as the ability to memorize a favorite position.

панель1-298x300_трим

In the spring, the product will already be available for purchase in the STRONGER dealer network. We hope this device will help you to spend your time on the water even more comfortably … https://stronger.in.ua/

#тримдлямотора #лебедкастронгер #якорнаялебедка #лебедканалодку #Stronger #лифтдлямотора #лифтдлялодочногомотора #тримдлялодочногомотора